Powerlink Solutions for Industrial Ethernet

In this Webinar Arrow Electronics and its partners are talking about Industrial Ethernet, also called real-time Ethernet. It provides an overview about Ethernet Powerlink and introduces a solution for a master control unit and a slave unit, both using Ethernet Powerlink.

Webinar Part 1: The first part of the Webinar gives a brief introduction on Industrial Ethernet, on field busses and technologies used then and now, with a focus on the physical layer, the communication/application structure. Current trends are also considered.
Speaker: Harald Fluegel, Specialized Field Application Engineer, Arrow Central Europe
>> View now

Webinar Part 2: The 2nd presentation introduces Ethernet Powerlink, one of the leading protocols for Ethernet-hardware based real-time  communication. The specific value proposition of Ethernet Powerlink is explained as well as the most important  reasons why to use this protocol.
Speaker: Stefan Schoenegger, General Manager Ethernet POWERLINK Standardization Group
>> View now

Webinar Part 3: In this presentation Arrow's example solution for a master control unit using Ethernet Powerlink is shown. The  solution runs on an i.MX evaluation board but, since it is a "soft" solution, can be ported to other processors  and boards as well.
Speaker: Daniel Krueger, Powerlink System Developer, SYS TEC electronic
>> View now

Webinar Part 4:  The fourth part explains Arrow's solution for a slave unit using Ethernet Powerlink. This solution bases on BeMicro  RTE - a small an cheap development platform for all kinds of Industrial Ethernet slaves.
Speaker: Harald Fluegel, Specialized Field Application Engineer, Arrow Central Europe
>> View now

Webinar Part 5: This part closes the Webinar and tells how to proceed in case you want to dig deeper.
Speaker: Harald Fluegel, Specialized Field Application Engineer, Arrow Central Europe
>> View now